Safety First
Keep the desk unplugged until assembly is complete. Two people are recommended for flipping and positioning the desk. Keep hands, cords and objects clear of the column travel path when the desk is moving.
Tools Required
- Cordless drill/driver with Phillips bit
- Allen keys (supplied with the base)
- Level and tape measure
Assembly Steps
- Place the worksurface upside down on a padded, clean surface.
- Extend the frame crossbar to match the worksurface width and center it using the pre-drilled holes or measurements in the base instructions.
- Attach the lifting columns and feet, then fasten the frame to the worksurface.
- Mount the control box and handset, and connect the column and handset cables.
- With help, turn the desk upright and adjust the feet so it is level.
Cable Management
Route all cables through the cable tray or spine, leaving enough slack for full travel from the lowest to the highest position. Make sure no cables can be pinched or pulled taut when the desk moves.
Initialization and Testing
Plug in the control box and run the reset/initialization sequence described in the base instructions. Test the full range of travel, set any memory presets, and confirm the anti-collision feature stops the desk when it meets resistance.
